Starrett 2000-24 Altissimo Electronic Height Gage Manual de usuario descargar pdf (Pagina 21)

Care and Maintenance

Starrett Altissimo Operation Manual Page 20 CAT 2000-24

Cleaning of the Glass Scale and Guide Ways:

Remove Top Cover – Use 3/16” (4.78 mm) Allen Wrench

to remove the top Cover. (See Figure 39)

Important: Cleaning the Glass Scale is a delicate

operation, therefore use extreme care.

Disconnect Cables – Disconnect the Display Cable and the

Ground Cable. (See Figure 40)

Remove Belt Lock Knob – Unscrew Belt Lock Knob and

remove. (See Figure 40)

Remove Outer Casing – Carefully lift the Outer casing off

towards the top of the tool in a straight line. Avoid contact

with any parts inside. (See Figure 40)

Clean Glass Scale – Carefully clean the Glass Scale with a

soft lint free cloth lightly dampened with Isopropyl

Alcohol. Next, coat the Scale by applying a greaseless

lubricant such as LPS

1† by saturating a lint-free cloth

then wiping it onto the surface of the glass and letting it

dry. (See Figure 41)

Clean Slide Bearing Tracks and Slide Bearings –

Carefully clean the 3 Slide Bearing Tracks and 3 Slide

Bearings outside diameter with a soft cloth or cotton swab

lightly dampened with Isopropyl Alcohol. (See Figure 42)

Clean Guide ways – Carefully clean the guide ways and 8

guide way bearings located along both sides of the column

with a soft cloth lightly dampened with Isopropyl Alcohol.

(See Figure 42)

Clean Drive Belt and Rollers – Carefully clean the 2

Rollers located at the top and 2 Rollers located at the

bottom of the column with a soft cloth lightly dampened

with Isopropyl Alcohol. Clean the side of the Drive Belt

that comes in contact with the rollers.

Replace the Cover – Reconnect the Display and Ground

Cables and replace the Top Cover. Be careful not to over

tighten the screws.

is a registered trademark of LPS

Laboratories, Inc.

1 2 ... 16 17 18 19 20 21 22 23

Sin comentarios

Starrett 2000-24 Altissimo Electronic Height Gage Manual de usuario Pagina 21